Telex AUDIOCOM BP-2000 Manual do Utilizador

TelexOperating InstructionsBP-2000/BP-1000Belt PacksAudiocom®IntercomSystemTalkCallChan12

INTERNAL SWITCHES, JUMPERS AND ADJUSTMENTSThere are several internal switches, jumpers and anadjustment that affect operation. These are described be

NOTE: On the BP-1000, jumper J3 must always havepins 2 and 3 shorted.Side Tone Adjustment (R19)The side tone adjustment is accessible either internall

TABLE 2. INTERNAL SWITCHES AND JUMPERSJUMPER/SWITCHNUMBERJUMPER OR SWITCH FUNCTION DEFAULTSETTINGSW1 Electret / Dynamic Microphone Select Dynamic^ (M

CONNECTOR PIN CONFIGURATIONSHeadset ConnectorType: XLR-4M (callout 6 in Figure 1)Pin 1 Headset microphone lowPin 2 Headset microphone highPin 3 Headp

BP-2000Type: One XLR-6M and XLR-6F pair (callout 7 in Figure1)Audiocom® Mode (Internal switch SW3 and jumpersJ2,J5, J6 and J7 set to BAL position)Pin

SPECIFICATIONSGENERAL:Power Requirements:Channel supplied: 24 VDC nominal, 45 to 70 mALocal-power: (BP-2000 only) 24 VDC nominal(14 to 30 VDC), 45 t

Unbalanced Intercom Channel:Output Level: 200 mVrms ±10%Input Impedance: 150W ±5%Bridging Impedance: greater than 10,000WCall Signalling:Send: 12

DYNAMIC MICROPHONE AMPLIFIER:Voltage Gain:Mic to Channel; 45 ±3 dB, before limitingMic to Headphone; adjustable, 65 dB range into 150WFrequency Resp

FACTORY SERVICEAll equipment returned for repair must be accompanied bydocumentation stating your return address, telephone numberand proof of date of

APPENDIX AOPTIONAL FOOTBALL MODIFICATIONSGENERAL DESCRIPTIONIn Audiocom® Intercom Systems, the Mic-Kill feature is usedto turn off any activated micro

GENERALThe Audiocom® BP-2000 and BP-1000 are microprocessorcontrolled one- and two-channel intercom belt packs. Aninternal switch and jumper setting

19

End-User License Agreement for Telex®SoftwareIMPORTANT - Please read this document carefully before using thisproduct.THIS DOCUMENT STATES THE TERMS A

OPERATIONSYSTEM POWERThe BP-2000 belt pack receives power externally, in one oftwo ways:· Via the intercom channel (similar to the BP-1000)· Via the l

4TALKCALL1 34588HEADSET LINES6HEADSET LINES776BP-1000BP-2000TALKCALLCHAN121 2345Figure 1. BP-2000 & BP-1000Connections and Controls

EXTERNAL CONNECTIONS & CONTROLSNOTE: The numbers refer to the callouts in Figure 1.1. Volume ControlUse this control to adjust the headset listen

Latched Mode:Tap the button once to talk. The indicator will glowgreen. Tap the button again when finished with aconversation.Momentary Mode:Press a

Local Power Input (BP-2000 only)Normally the BP-2000 is powered from the intercomsystem and will turn on with the intercom system. TheBP-2000 belt pa

2. Press and hold theTalkkey, then press and hold theCallkey, then release both keys. TheCallindicator shouldnow glow red.(The number of beeps heard