Telex Integrated Signal Processor ISP-100 Manual do Utilizador descarregar pdf (Página 122)

8-52

10 July 1998

Select

Figure 8-20

Select component.

The select function (see Figure 8-20) allows you to set the source that

feeds portions of a QuickMAP. The user is allowed to select from as

many inputs as the QuickMAP allows. An entire QuickMAP can be fed

from a single source or multiple sources depending on the settings of the

Selects within the QuickMAP.

Note

: The amount of available sources is determined by the QuickMAP

and not the hardware configuration. For example: A particular QuickMAP

has three source selects in it. This will require two input cards. The user

is only able to select from three inputs (as determined by the QuickMAP)

even though two input cards provide a total of four inputs in terms of

hardware.

Selecting the Input

To select the input click on the button next to the input that you want

to make active. The LED on the button should turn from gray to

green. If a particular button is grayed out then it is not available for

selection.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 145 146

Sem comentários

Telex Integrated Signal Processor ISP-100 Manual do Utilizador Página 122